The VectorStar ME7838x series of broadband systems covers a range of 70 kHz to 110/125/145/220 GHz. The distinctive architecture of the Anritsu NLTL mmWave modules offer a DC path between the baseband VNA and the DUT through the module. This beneficial design offers the opportunity to switch between the baseband VNA for non-broadband applications and the mmWave module for on-wafer broadband measurements. An additional benefit is the ability to attach a Kelvin bias tee to the input side of the module for DC Kelvin biasing. This unique ability offers the opportunity to optimize Kelvin bias tee performance for the application and DUT characteristics as needed without having to perform major design changes within the mmWave module as found in other designs.
Most Recent Flipbooks
Material measurement will become an even more important measurement to be performed on all devices that carry high-frequency signals. Characterizing the materials for their electrical loss properties
Bluetooth® Low Energy (LE) Audio products continue to evolve, offering new user experiences. This document provides the technical details of LE Audio technologies and the significant advancements that
This paper discusses methods for transferring the sensor-based calibration to the probe tip using user power calibrations and power embedding/de-embedding for broadband and banded millimeter-wave (mmW
This document explains how to use a scenario to automate testing using the Network Master Pro MT1040A and the OSA MS9740B when deploying 400ZR and helps reduce data center interconnect operation costs

A transformational era in military and defense is underway and has an underpinning of 5G
Learn the challenges of testing 5GNR base stations and how to test the performance outside of traditional methods.
Automotive services operate at specific angular ranges in relation to the vehicle like Mobile Network communication
5G NR has opened up many verticals enabling all-around user experience expanding into the automotive space.
In testing the cellular capability of Telematic Control Unit (TCU) it is important to test abnormal situations that may arise due to misconfigurations, bad state actors, or the current conditions resu
This application note explains the necessity of inspection testing by RF evaluation of each of the three IEEE 802.11ax-specified frequency bands (2.4, 5, and 6 GHz).
The rollout of 70 GHz–80 GHz 5G systems and the subsequent need for more E-band devices (like radar antennas) has placed greater importance on using VNAs
Manual testing is commonly used to confirm device under test (DUT) functionality, but in terms of scope it is impossible to use this test method to verify all permutations of RF parametric measurement
Automobile equipment is using cellular communications for remote diagnostic monitoring of vehicle subsystems condition, Infotainment systems, and smartphone applications
V2X communications utilize RF (Radio Frequency) technology
Today, vehicles include various complex subsystems that are controlled through a Telematic Control Unit (TCU)
Pre-testing eCall at the TCU module vendor and at the automaker reduces costly delays of failure in the certification testing