Rubidium’s analog sweep capability and generated sweep synchronization outputs can be used to make amplitude response measurements of active and passive devices.
More information on the Rubidium RF/Microwave Signal Generator.
Most Recent Videos
10:36Introduction to 110 GHz ONA solution for measuring Opto-electronic devices and components
2:49A short video explaining how to make BR / EDR / BLE measurements on a Bluetooth module using the Anritsu MT8852B test instrument and the CombiTest software.
4:14A short video explaining how to use the Anritsu MT8852B test set and the MX885203A low energy software to perform Bluetooth low energy tests.
9:28performance advantages and design innovations of the Anritsu Rubidium Signal Generator Family
10:04New PhaseLync enabled ME7869A modular, distributed 2-port VNA helps users make Vector corrected S-parameter measurements over long distances up to 100 meters
2:13Test long cable runs across aircrafts, naval ships, large anechoic chambers, and other tasking environments, with simplicity and accuracy
3:36This video highlights the method for using markers in the Vision high-speed port scanner option 407
23:16This video covers the fundamental operation of the Remote Spectrum Monitor MS2710xA web based graphical user interface (GUI), via a wireless or wired LAN connection enabling a new and innovating way
5:09TETRA base station receiver testing with the LMR Master S412E with hardware and software setup instructions.
1:31The Next Generation Anritsu Site Master represents a fusion of cutting-edge technology, customer-driven innovation, and decades of expertise in test and measurement solutions. It seamlessly integrates
3:53Non-Terrestrial Network (NTN) NB-IoT is one of the key topics and lead deployments for satellite ‘direct to device’ communication.
