The introduction of active antenna systems on 5G base stations requires engineers installing and maintaining them to use alternative measurement methods, such as effective isotropic radiated power (EIRP) for transmitter power and beam verification. This application note highlights how the Anritsu Field Master Pro™ MS2090A facilitates the "over-the-air" (OTA) measurement of EIRP on active base stations using an accessory dual polarized waveguide antenna. Measurements are performed according to 3GPP specifications and are ideal for product design verification and field installations.
Most Recent Flipbooks
A transformational era in military and defense is underway and has an underpinning of 5G
Learn the challenges of testing 5GNR base stations and how to test the performance outside of traditional methods.
Automotive services operate at specific angular ranges in relation to the vehicle like Mobile Network communication
5G NR has opened up many verticals enabling all-around user experience expanding into the automotive space.
In testing the cellular capability of Telematic Control Unit (TCU) it is important to test abnormal situations that may arise due to misconfigurations, bad state actors, or the current conditions resu
This application note explains the necessity of inspection testing by RF evaluation of each of the three IEEE 802.11ax-specified frequency bands (2.4, 5, and 6 GHz).
The rollout of 70 GHz–80 GHz 5G systems and the subsequent need for more E-band devices (like radar antennas) has placed greater importance on using VNAs
Manual testing is commonly used to confirm device under test (DUT) functionality, but in terms of scope it is impossible to use this test method to verify all permutations of RF parametric measurement
Automobile equipment is using cellular communications for remote diagnostic monitoring of vehicle subsystems condition, Infotainment systems, and smartphone applications
V2X communications utilize RF (Radio Frequency) technology
Today, vehicles include various complex subsystems that are controlled through a Telematic Control Unit (TCU)
Pre-testing eCall at the TCU module vendor and at the automaker reduces costly delays of failure in the certification testing
Using the New Radio Non-Standalone Architecture (NR NSA) mode, a wider bandwidth can be implemented by aggregating both the LTE and NR carrier waves.
All the wireless standards, including mobile, short-range wireless, and navigation, help to keep the driver connected everywhere
In testing the cellular capability of a Telematic Control Unit (TCU), it is important to test abnormal situations that may happen in the cellular network.
New Radio (NR) with its flexible architecture and capability to provide higher order throughputs with reduced latency enables the vehicles of future to deliver these services.
Delta-L is an algorithm developed by Intel for PCB manufacturers for verifying PCB design. Vector Network Analyzer serves an important requirement for all PCB manufacturers in order to be compliant
This application note shows how to extract 2x-thru to 1x-thru using the equation editor feature in offline mode since 2x-thru is the most popular network extraction method for splitting into two (2) 1
This paper provides a step-by-step guide to perform calibration and measurement to show a “pass” or “fail” result of the device under test.